# Interface Conditions

## Interface Conditions

It is also necessary to specify boundary conditions at an interface between two different media. At interfaces between two different diffusion media (such as between the reactor core and the neutron reflector), on physical grounds the neutron flux and the normal component of the neutron current must be continuous. In other words, φ and J are not allowed to show a jump.

It must be added, as J must be continuous, the flux gradient will show a jump if the diffusion coefficients in both media differ from each other.

## Example: Two different diffusion media

A diffusion environment may consist of various zones of different composition. The consequence of this is that the diffusion coefficient, absorption macroscopic cross-section, and therefore, the neutron flux distribution, will vary per zone. For the determination of the flux distribution in various zones, the diffusion equations in zone 1 and zone 2 need to be solved:

where a is the real width of zone 1 and b the outer dimension of the diffusion environment including the extrapolated distance. With problems involving two different diffusion media, the interface boundary conditions play crucial role and must be satisfied:

At interfaces between two different diffusion media (such as between the reactor core and the neutron reflector), on physical grounds the neutron flux and the normal component of the neutron current must be continuous. In other words, φ and J are not allowed to show a jump.

1., 2. Interface Conditions

It must be added, as J must be continuous, the flux gradient will show a jump if the diffusion coefficients in both media differ from each other. Since the solution of these two diffusion equations requires four boundary conditions, we have to use two boundary conditions more.

3. Finite Flux Condition

The solution must be finite in those regions where the equation is valid, except perhaps at artificial singular points of a source distribution.  This boundary condition can be written mathematically as:

4. Source Condition

The presence of the neutron source can be used as a boundary condition, because it is necessary that all neutrons flowing through bounding area of the source must come from the neutron source. This boundary condition depends on the source geometry and for planar sourve can be written mathematically as:

For x > 0, these diffusion equations have the following appropriate solutions:

Φ1(x) = A1exp(x/L1) + C1exp(-x/L1)

and

Φ2(x) = A2exp(x/L2) + C2exp(-x/L2)

where the four constants must be determined with use of the four boundary conditions. The typical neutron flux distribution in a simple two-region diffusion problem is shown at the picture below.

References:
Nuclear and Reactor Physics:
1. J. R. Lamarsh, Introduction to Nuclear Reactor Theory, 2nd ed., Addison-Wesley, Reading, MA (1983).
2. J. R. Lamarsh, A. J. Baratta, Introduction to Nuclear Engineering, 3d ed., Prentice-Hall, 2001, ISBN: 0-201-82498-1.
3. W. M. Stacey, Nuclear Reactor Physics, John Wiley & Sons, 2001, ISBN: 0- 471-39127-1.
4. Glasstone, Sesonske. Nuclear Reactor Engineering: Reactor Systems Engineering, Springer; 4th edition, 1994, ISBN: 978-0412985317
5. W.S.C. Williams. Nuclear and Particle Physics. Clarendon Press; 1 edition, 1991, ISBN: 978-0198520467
6. G.R.Keepin. Physics of Nuclear Kinetics. Addison-Wesley Pub. Co; 1st edition, 1965
7. Robert Reed Burn, Introduction to Nuclear Reactor Operation, 1988.
8. U.S. Department of Energy, Nuclear Physics and Reactor Theory. DOE Fundamentals Handbook, Volume 1 and 2. January 1993.